[. . . ] Risk of electric shock  Do not use near water contained in bathtubs, sinks, or in other containers. Parts and operating controls 1 Kettle (with water level indicator) 2 Lid 3 Lid release button 4 ON/OFF O switch 5 Temperature indicator (illuminated) 6 + – button (temperature setting) 7 keep warm button 8 Limescale filter (removable) 9 Base 1 0 Cable tidy Important Use the kettle 1 only with its included base 9. [. . . ] Before using for the first time ●● Remove any stickers or film. —● Unroll the right amount of cable from the cable tidy 10 and plug it in. —● Check the amount by reading the water level indicator markings (min and max). —● Close the lid 2 until it locks and place the kettle 1 on the base 9. The kettle emits a signal, and the factory-set temperature (100°C) lights up. —● By pressing button 6 + or – you can set the temperature to ca. —● When the water has reached the selected temperature, the kettle will switch off automatically, the temperature indicator 5 goes off, and a signal sounds. Note: The selected temperature can be changed at any time while the kettle is heating up. While the kettle heats up, the current temperature lights up; the preset temperature flashes until it has been reached. If the temperature cannot be set, this indicates that the water in the kettle is hotter than the desired temperature. Note: The keep warm feature switches off automatically after 30 minutes. 2011 15:25:14 en 7 Cleaning and maintenance Troubleshooting The kettle does not heat up; the temperature indicator 5 does not light up. [. . . ] A Guarantee The guarantee conditions for this appliance are as defined by our representative in the country in which it is sold. Details regarding these conditions can be obtained from the dealer from whom the appliance was purchased. [. . . ]